SK-404

Doc no. SK-404DatasheetRev 2026.11Sheet 2.6 of 4

H6

Solder Reflow Pad

KiCad hotplate PCB for reflowing SMD parts and prototyping at the bench, with custom top and bottom silkscreen artwork.

Prototype

01

Block diagram

12 V jackDC input REG1117-5.05 V rail ATtiny1614SOIC-14 · UPDI AO4406ALheater switch Copper spiral1MM_HOT_PLATE OLED · UIbuttons · buzzer TEMP0 · AMBIENTsensor headers
Fig. 1: 12 V in, a copper spiral out
02

Characteristics

Board95.25 × 68.56 mm, 2 layers, 1.6 mm FR-4, four M3 mounting holes; 2 oz copper and ENIG recommended
Heater elementSquare copper spiral (1MM_HOT_PLATE) covering most of the board surface, powered from a 12 V DC jack
ControlATtiny1614 (SOIC-14) switching an AO4406AL MOSFET, plus REG1117-5.0, 2N3904, START/SELECT buttons, buzzer and OLED header
HeadersBreakout headers for plate thermistor (TEMP0), ambient sensor (AMBIENT0), cooling fan (FAN0) and UPDI programming (PGM0)
ScopeBoard-only layout (.kicad_pcb + .kicad_pro): firmware and pre-exported Gerbers are not bundled
  • KiCad
  • 2-layer
  • Silkscreen art
03

Overview & build notes

A self-heating 2-layer FR-4 PCB designed for small SMD reflow and bench preheating: driving 12 V into the 1MM_HOT_PLATE copper spiral heats the board surface directly under a passive or pasted assembly while a dedicated control strip along the right edge houses the controller and UI.

The control stage pairs an ATtiny1614 (SOIC-14, UPDI programmable via PGM0) with a logic-switched AO4406AL MOSFET, REG1117-5.0 5 V supply, two 12 mm tactile buttons (START / SELECT), status LEDs, a buzzer and a 4-pin OLED header.

Recommended fabrication calls for 2 oz copper, high-temperature solder mask and ENIG finish to resist oxidation across repeated thermal cycles, with heavy 16–18 AWG silicone power leads.

04

Figures & renders

Top 3D render of the Solder Reflow Pad PCB showing the copper spiral heater and ATtiny1614 controls
Fig. 2 3D top render: copper spiral heater element with warning silkscreen and right-edge controller strip
05

Files & artifacts

KindFileDetailsSize
KiCadSolder_Reflow_Pad.kicad_pcbComplete 2-layer KiCad 10 PCB layout with copper spiral heater and controller212 KB
DocsREADME.mdPart-by-part BOM table, fabrication specs and thermal notes on GitHubGitHub