SK-404

Doc no. SK-404DatasheetRev 2026.11Sheet 2.1 of 4

H1

Card Wallet

A minimalist card wallet designed as an FR4 printed circuit board in KiCad.

Prototype

01

Block diagram

KiCadcard_board.kicad_pcb Edge.Cutsoutline + NPTH Fab filesEdge_Cuts.gm1 · .drl FR4 board85.6 × 54 mm plate
Fig. 1: From KiCad to a board you carry
02

Characteristics

Dimensions85.60 × 54.00 mm with 3.00 mm corner radii — exact ISO/IEC 7810 ID-1 credit-card footprint
Stackup1.0 mm (or 1.6 mm) 2-layer FR-4 glass-epoxy laminate; zero electrical nets
Mounting holesFour 2.20 mm non-plated corner holes (H1–H4) inset 4.00 mm (77.6 × 46.0 mm centres) for M2 screws or elastic
Design filecard_board.kicad_pcb holds the routed mechanical outline (Edge.Cuts) and NPTH array
Fab outputsPre-plotted card-Edge_Cuts.gm1 outline Gerber and card-NPTH.drl Excellon drill file
  • KiCad
  • FR4
03

Overview & build notes

Two rigid FR-4 fiberglass plates cut to exact ISO/IEC 7810 ID-1 card dimensions (85.60 × 54.00 mm with 3.00 mm rounded corners) sandwich a stack of cards cleanly without leather bulk.

Each corner carries a 2.20 mm non-plated through-hole (H1–H4, inset 4.00 mm with 2.90 mm edge web) sized for standard M2 standoffs or a flat woven elastic band, leaving the copper and solder-mask layers free for custom silkscreen or bare matte black FR-4.

Both the primary KiCad 8/9 board file and pre-plotted fabrication outputs (card-Edge_Cuts.gm1 and card-NPTH.drl) are included directly below so plates can be inspected or sent straight to any PCB fabricator.

04

Figures & renders

Top raytraced render of the Card Wallet FR4 plate showing H1 through H4 corner holes
Fig. 2 Top 3D render: 85.6 × 54.0 mm outline with R3.0 mm corners and M2 NPTH holes
Bottom raytraced render of the symmetrical Card Wallet FR4 plate
Fig. 3 Bottom 3D render: symmetrical matte finish ready for standoff or elastic assembly
05

Files & artifacts

KindFileDetailsSize
KiCadcard_board.kicad_pcbProduction KiCad layout containing the ID-1 mechanical outline and NPTH holes5 KB
Gerbercard-Edge_Cuts.gm1Pre-plotted Edge.Cuts Gerber outline for PCB fabrication429 B
Drillcard-NPTH.drlExcellon non-plated drill file for the four 2.20 mm M2 corner holes169 B
DocsREADME.mdMechanical ratings, fab stackup options and assembly steps on GitHubGitHub