SK-404

Doc no. SK-404DatasheetRev 2026.11Sheet 2.2 of 4

H2

ESP32 Sensor Probe

Environmental probes: an ESP32 with a BME280 and a 1.14-inch IPS display, and an Arduino Uno with a DHT22 and an OLED. Arduino and MicroPython firmware.

Prototype

01

Block diagram

BME280temp · humidity · press ESP32Arduino C++ / MicroPython ST7789 IPS1.14" · 135 × 240 DHT22temp · humidity Arduino Unomemory-optimised sketch SSD1306 OLED0.96" · I²C
Fig. 1: Two sensor probes
02

Characteristics

ESP32 probeBME280 temperature, humidity and pressure sensor driving a 1.14" 135×240 RGB IPS (ST7789)
Display modesFour live views cycled via BOOT (GPIO 0): dashboard, thermal sparkline, meteorology diagnostics (dew point, heat index) and large digits
BoardsConfigured with profiles for both a generic ESP32 DevKit + SPI screen and LilyGO TTGO T-Display
Uno probeMemory-optimised Arduino Uno sketch for a DHT22 and 0.96" SSD1306 I²C OLED using zero external libraries
UtilitiesIncludes MicroPython implementations plus i2c_scanner.ino and raw-I²C force_oled_test.ino diagnostics
  • ESP32
  • BME280
  • MicroPython
  • Arduino
03

Overview & build notes

Two standalone environmental monitor builds share one repository: a colour ESP32 + BME280 + ST7789 IPS probe (with matching Arduino C++ and MicroPython firmware) and a minimal Arduino Uno + DHT22 + SSD1306 OLED station.

On the ESP32 probe, differential bounding-box redraws keep the 135×240 SPI display flicker-free at interactive speeds, while GPIO 0 short-presses cycle through four readout modes and long-presses toggle °C/°F. GPIO 35 resets tracked min/max extremes.

For quick bench debugging on the Uno side, the sketch talks to the SSD1306 OLED over bare Wire.h to stay comfortably within ATmega328P SRAM limits without pulling third-party display dependencies, paired with standalone I²C address-scanner and bus-recovery test sketches.

04

Files & artifacts

KindFileDetailsSize
GuideESP32_BME280_PROBE_GUIDE.mdComplete wiring diagrams, GPIO pinouts and library setup manual5 KB
Arduinoesp32_bme280_probe.inoMulti-mode ST7789 + BME280 Arduino C++ firmware on GitHubGitHub
Pythonesp32_bme280_probe_micropython.pyMicroPython port for ESP32 DevKit or TTGO T-Display on GitHubGitHub
Arduinoweather_station.inoZero-library Arduino Uno DHT22 + SSD1306 OLED sketch on GitHubGitHub
Tooli2c_scanner.ino115200-baud I²C address probe (0x3C / 0x3D) on GitHubGitHub